May. 26, 2025
RV converters and RV inverters are essential to supply the correct type of electricity to your RV appliances. The video above helps explain why these two devices are essential and where to find them in your RV. But here’s a written breakdown.
Goto ARCSEC DRIVE to know more.
Table of Contents
When you hook your RV up to 30 or 50-amp shore power, that power comes into your RV as alternating current (AC). An RV converter changes that 120-volt AC to 12-volt direct current (DC), allowing you to use appliances that require DC and charge your RV battery simultaneously. Your converter will typically be found next to your RV’s fuse box and breakers.
When it goes bad, your converter will give you one of three main warning signs. These can vary depending on make and model, but you’ll typically see one of three things when your RV converter goes bad:
Both of these final points can be signs that these small RV appliances aren’t getting enough power.
Testing an RV converter is a delicate process that must be completed in the correct sequence. Consult your owner’s manual for specific testing instructions from the manufacturer, as the exact voltages and recommended testing sequence may vary from model to model.
But these quick tests will help you test most RV power converters:
If no blown fuses are found, the connections to the battery and/or converter aren’t reversed, and you’re still getting an output voltage of 0.0 volts DC, contact the manufacturer or your nearest Camping World Service Center for further troubleshooting assistance.
Some RV converters are also equipped with an AC reverse polarity protection feature. If the AC neutral wire and the lead wire coming into your converter are connected backward, it triggers this protection feature and shuts your converter down.
Some converters may have an audible alarm that sounds when the AC wires aren’t connected properly. If your converter is equipped, the alarm will continue to sound until the wires are appropriately reconnected.
If your RV is unplugged and your battery dies, you’ll be without power in your coach. Using your RV without a battery isn’t recommended, as the 12-volt components inside often draw more amperage than your converter can supply.
Your battery is essential for providing the power to operate these components safely. If your RV is plugged in and the battery is disconnected, some small electronics, such as RV lights, may work off the converter alone. But maintaining a healthy battery in your RV is essential to safe RV use.
If you do need to disconnect your battery for any reason, power off all 12 volt appliances inside. Then consult your owner’s manual for the proper disconnection and replacement procedures.
If you’re dry camping or boondocking and not using a generator, installing an RV inverter is a good idea if your RV didn’t come with one pre-installed. RV inverters change DC to AC, but you’ll need to consult your owner’s manual for specifications on what type of inverter suits your RV and the appliances you want to power.
Use this sequence to test if your RV’s inverter is functioning correctly:
Most RV inverters only operate one or two circuits of your RV’s electrical system. Some high-end luxury RVs offer the ability to invert all circuits using multiple inverters. But most RV inverters power specific outlets or appliances, such as your refrigerator, microwave, or television.
Your owner’s manual will tell you which outlets or appliances should be powered by your inverter. But if you’re having trouble locating that information, contact your RV’s manufacturer.
If all the appliances and outlets on the inverter’s circuits are working properly, your inverter is doing its job. But further troubleshooting is required if you encounter a lack of power at any outlet or appliance.
Different symptoms will call for different RV inverter troubleshooting procedures. Because there are various inverter makes and models out there, your owner’s manual is your best resource for specific troubleshooting procedures.
Want more information on rv reducer? Feel free to contact us.
That being said, here are some general troubleshooting tips for RV inverters:
A healthy RV battery should have a voltage above 12.5 volts DC. If the voltage is between 12.5 and 10 volts DC, your battery may be wearing out, but it may just need to be charged. Charge it until you get a reading of about 12.5 volts DC and wait 2-3 hours before retesting.
If the voltage is below 10 volts DC on the initial test, your battery may be bad, but it may also need to be recharged. If there’s a continuous draw on the battery, such as a light that was left on, it could draw the battery below 10 volts DC. While this may shorten the battery’s life, it doesn’t mean you have a bad battery.
Please refer to our guide on troubleshooting RV batteries and lights for tips on ensuring your RV is equipped with healthy coach and engine batteries. And if you have determined you have a battery, you’ll need to replace your RV battery before further testing.
If it is below the minimum threshold, you have an inadequate shore power source that could damage your RV’s electrical system. You should already be utilizing a surge protector to protect your RV, but disconnect immediately if you find low voltage.
If your breaker trips again or is repeatedly doing so, there are two possibilities: a defective breaker or the appliance is drawing too much battery power. In either case, consult an RV service technician for advice on your best course of action.
Working with electrical systems on recreational vehicles can be tricky. While they’re not overly complicated, minor errors when troubleshooting can damage sensitive appliances. Sometimes, you’re better off scheduling an appointment at your nearest Camping World Service center.
And if you’re still learning the ins and outs of RV maintenance, check out our downloadable RV ownership and maintenance booklet!
But if you want to enjoy the RV lifestyle without worrying about RV maintenance, consider renting an RV for your next adventure.
What additional questions or comments do you have about RV converters and inverters? Leave them in the comments below!
The information provided in this blog is for general informational purposes only and not intended to take the place of professional service providers. While we strive to provide accurate and up-to-date information, we make no representations or warranties of any kind, about the completeness, accuracy, reliability, suitability, or availability with respect to the information, products, services, or advice contained on the blog for any purpose. Any reliance you place on such information is therefore strictly at your own risk. In no event will we be liable for any loss or damage including without limitation, indirect or consequential loss or damage, or any loss or damage whatsoever arising from loss of data or profits arising out of, or in connection with, the use of this blog.
This file format is not supported
Videos must be at least 5 seconds.
The file size is too big. A video can be up to 1 GB
We encountered a problem while trying to upload. Please try again
You have uploaded the maximum number of photos
You may only upload one video per answer
The company is the world’s best exoskeleton joint actuator supplier. We are your one-stop shop for all needs. Our staff are highly-specialized and will help you find the product you need.
If you are interested in sending in a Guest Blogger Submission,welcome to write for us!
All Comments ( 0 )